Description
Flush QD Mount for plastic stocks or handguards.
Steel QD mount and nut
Low-Profile
4 Position, rotation limited
Can be mounted in most hollow plastic stocks
Uses standard QD Swivel (Not included)
Weight: 0.3oz The Flush QD Mount can be installed in most plastic stocks that are hollow and handguards that have a relatively flat section. Installation requirements
A 1/2″ hole must be drilled
Material thickness of less than 1/4″
5/8″ wrench
QD Swivel
Permanent thread locker is recommended
later2u (verified owner) –
Needed a QD solution for my KS7. This fit the bill.
Anonymous (verified owner) –
No way to tighten without damaging the edge if trying to hold outer QD,threads are coated and won’t let nut tighten, should be made with hex in the QD housing to hold for tightening